Network_Appliance
NS0-504 · Question #341
After proper cabling, enabling the FC ports on the initiator and target, and creating a LIF within a Vserver, you still are not able to see the initiator using the Vserver fcp initiator show…
The correct answer is D. The Initiator will not appear until you create a LUN within the Vserver. See the full explanation below for the reasoning.
Question
After proper cabling, enabling the FC ports on the initiator and target, and creating a LIF within a Vserver, you still are not able to see the initiator using the Vserver fcp initiator show command. What is the likely cause?
Options
- AThe initiator and target are not properly zoned on the Fibre Channel switch.
- BThe initiator is probably coming over an indirect path and this command does not display initiator
- CThe initiator will not appear until a LUN is mapped to Igroup within the Vserver
- DThe Initiator will not appear until you create a LUN within the Vserver.
How the community answered
(30 responses)- A10% (3)
- B7% (2)
- C3% (1)
- D80% (24)
Community Discussion
No community discussion yet for this question.