Network_Appliance
NS0-182 · Question #27
Recently, your 2-node FAS8020 cluster was upgraded from ONTAP 8.3 to ONTAP 9.5. You have just added two FAS8060 nodes to the cluster. You have executed Config Advisor to verify your work. Config…
The correct answer is B. Flow Control should be set to ALL. See the full explanation below for the reasoning.
Question
Recently, your 2-node FAS8020 cluster was upgraded from ONTAP 8.3 to ONTAP 9.5. You have just added two FAS8060 nodes to the cluster. You have executed Config Advisor to verify your work. Config Advisor tells you that the cluster ports on the original two FAS8020 nodes have Flow Control set to FULL. In this scenario, to what should the Flow Control setting on the FAS8020 ports be set?
Options
- AFlow Control should be set to SEND.
- BFlow Control should be set to ALL.
- CFlow Control should be set to RECEIVE.
- DFlow Control should be set to NONE.
How the community answered
(68 responses)- A4% (3)
- B85% (58)
- C9% (6)
- D1% (1)
Community Discussion
No community discussion yet for this question.