NS0-176 Exam Questions

You just finished cabling a UCS 5108 chassis to the Fabric Interconnects. Which diagram in the exhibit is cabled correctly according to the CVD guidelines?

Your primary VSM needs to be edited, rebooted, or migrated. You need to initiate a manual switchover to your standby VSM. What command will allow this to occur?

Which hardware component is shown in the exhibit?

You are an administrator of a UCS system. You notice that when you apply a setting that requires a reboot, the affected hardware reboots immediately without warning. You would like...

Referring to the exhibit, which two diagrams show the correct way to cable a new NetApp clustered Data ONTAP cluster with two nodes? (Choose two.)

There are 2 chassis tied to a pair of Fabric Interconnects. First chassis, chassis-1, has 1 link between single IOM and Fabric Module. Second chassis, chassis-4, has 4 links betwee...

After deploying a FlexPod solution, which tool would you use to validate a successful installation?

The NetApp Vistual Storage Console is used to set which three setting categories on ESXi hosts? (Choose three.)

A Cisco UCS system is operating in FC End-Host Mode. The fabric Interconnects are uplinked into Nexus 5672UP switches using native FC. The service profiles are unable to boot from...

Which FlexPod management tool allows you to manage Storage Virtual Machines (SVMs) and replication relationships?

A customer wants a newly deployed UCS C-Series server's fans to run at the minimum speed required to keep the server cool. The customer is also complaining that the server fans are...

Your customer needs a new Nexus switch that can support at least ten 40GbE ports, and has room for future growth. Your customer would also like the new switch to be Application Cen...

When trying to configure a Virtual Port Channel (vPC), what might be a cause of the following error when trying to create the vPC domain? Nexus-5548-B(config)# vpc domain 10 ^% Inv...

You are asked to install the Virtual Supervisor Module (VSM) software on a Nexus 1000v switch. Which two sources would you use to install this software? (Choose two.)

How many ACTIVE SPAN sessions exist on a Fabric Interconnect?

A customer wants to reuse existing networking equipment that was pulled from another data center for a new FlexPod Datacenter solution. They want to know if their switch models are...

What aggregate containing the root volume is created during the Clustered Data ONTAP setup process?

Which statement is true for Fibre Channel QoS System Class?

Which two technologies must be deployed for a Cisco Nexus 9000 ACI design? (Choose two.)

You currently have a FlexPod Datacenter solution, and you are merging with another company. That company's environment currently has a mix of different Cisco servers. You want to a...

You just configured a new Storage Virtual Machine named SVM1 on your NetApp cluster to serve up NFS datastores to an ESX cluster. Your VMware administrator tells you that the ESX s...

An administrator is building a FlexPod configuration with UCS 6296 Fabric Interconnect devices that support legacy Fibre Channel 9FC) connections. The administrator uses UCS Manage...

Which server role is required to support running virtual machines on a Microsoft based hypervisor?

Which feature allows Cisco Nexus 7000 Series switches to be virtualized at the device level?

Which statement is true about NFS exports in Clustered Data ONTAP?

An administrator has a FlexPod solution configured for Microsoft Hyper-V 2012 R2. The hypervisor will be using CIFS shares for Cluster Shared Volume (CSV) datastores. A storage vir...

You are configuring iSCSI boot from SAN on your UCS blades. Referring to the exhibit, how many paths will there be to the Boot LUN?

When configuring a volume to contain a LUN, which administrative tool automatically applies NetApp recommendations?

VMware ESXi 6 supports which three storage protocols? (Choose three.)

You have a FlexPod solution with Cisco 6296UP Fabric Interconnects. You currently have a direct-attached AFF8040 system using FCoE for storage connectivity. You would like to recon...

On a NetApp clustered Data ONTAP cluster, a volume named datastorel resides on an aggregate named node1 aggr1 and is mounted into the namespace at the junction path /esx cluster1/d...

Which three are true for UCS 2208XP? (Choose three)

Which aggregates should be disabled for data aggregates?

Your customer has the storage configuration for a FlexPod solution shown below. - FAS8040 HA-pair - Disk stack one-4x DS4243 disk shelves (2TB SATA disk drives) - Disk stack two- 2...

Which two are the expected outputs of network interface show? (Choose two.)

Under which tab in UCS Manager would you create a boot policy?

You run NetApp ConfigAdvisor against you FAS8060A storage system. The report states that the flow control settings for ports e0a on each node are incorrect. Which set of commands w...

Your customer has a FlexPod VMware solution deployed with NFS datastores. As shown in the exhibit, the links between the Fabric Interconnects and storage controllers are single-mod...

Your company is looking for a small remote office infrastructure to deploy to your 30 remote sites. You are asked to write deployment procedures for each site. Your goal is to have...

A customer uses Cisco Intersight and now wants to monitor their NetApp storage system with Intersight. In this scenario, which three actions must be completed to accomplish this ta...

Which three management tools would you use to configure the NetApp storage component in a FlexPod Datacenter solution? (Choose three.)

Your company has acquired a new NetApp EF600 storage array with a 25 Gbps HIC. In this scenario, which FlexPod-supported protocol should be used to connect to this array?

Refer to the exhibit. What management tool may be used for creating virtual machines?

When configuring a FlexPod environment for iSCSI boot with Cisco UCS, which item should be preconfigured?

Which two are true about Fabric Interconnect L1 and L2 ports in cluster mode? (Choose two)

An administrator has a FlexPod solution using VMware vSphere 6.0. The ESXi hosts use iSCSI for storage connectivity, and all paths have been configured and connected between the Ne...

How should the speed be configured on the Nexus 5548 port connecting to the Nexus 1100-X?

Which three elements are included in a UCS service profile? (Choose three.)

An administrator has a Flexpod solution configured to use VMware vSphere 6.0. All virtual machines will reside on NAS datastores. Certain critical virtual machines have a requireme...

Which of the following tools is designed to inventory existing VMware vSphere, Linux, and Microsoft Windows Server versions in a customer environment?