NS0-170 Exam Questions

What happens when the diag dump command is executed?

The flush cache command _____.

NetApp Services include all of the following EXCEPT ______.

Which one of the following will show all of the NetCache appliance's current configuration settings?

Which one of the following actions cannot be accomplished from the NetCache command line?

When sending a packet beyond the local area network, the NetCache uses all of the following EXCEPT _____ to decide which router to send the packet to.

The ___ command is used to run automated diagnostic analysis routines.

A packet trace captured by the NetCache can ____ .

Which one of the following NetCache Utility feature captures packets arriving or leaving on the network interfaces?

Which command would you use to see the available option choices for the show config.http.acl command?

A hierarchy consists of a child and a _____ NetCache where the _____ NetCaches may be in a _____ configuration.

Which one of the following NetCache appliances has a maximum storage capacity of 504G Bytes?

A complete listing of Network Appliance support centers is available at _____.

Which one of the following services is not a service supported by ICAP?

When configuring NTLM authentication you must specify the _____.

With clustered Data ONTAP 8.3, which construct contains data volumes and one or more LIFs through which they serve data to clients?

You are asked to design an application-focused data center using policy-based networking. Which architecture is valid for this new design?

What are two valid cluster interconnect switches? (Choose two.)

Which UCS Manager feature will allow you to have a consistent server configuration within the system?

A FlexPod design will be using a 4-node NetApp storage solution and requires a switch for the cluster interconnect. Which two switches are valid in this scenario? (Choose two.)

A customer is designing a FlexPod with VMware vSphere 6.0. There is a requirement to centralize backup management of virtual machines with the ability to view storage configuration...

An administrator wants to see both the NetApp storage utilization values and the UCS port network capacity in the same dashboard. Which management tool provides this capability?

Which mode must your Fabric Interconnects be using to participate in the Spanning Tree Protocol (STP) and send Bridge Port Data Units (BPDUs)?

An architect is designing an Oracle FlexPod solution that must support non-disruptive upgrades across all of the hardware components. The Oracle workload requires a 4-node FAS syst...

A customer is evaluating management tools for a new FlexPod Infrastructure. They desire a tool that can orchestrate the provisioning of UCS compute nodes, NetApp storage, and VMwar...

You are configuring VMware ESXi to support QoS across the entire FlexPod environment. Which MTU setting is required to accomplish this task?

An architect is attempting to confirm that all logical interfaces (LIFs) are properly planned with a new clustered Data ONTAP 8.3 implementation. The customer wants to provision NF...

You are deploying VMware on a FlexPod and require back up and space efficient cope services for VMware virtual machines. Which two are required to accomplish this task? (Choose two...

In addition to what is used in a FlexPod Datacenter design, which new hardware component is required to support Cisco Application Centric Infrastructure (ACI)?

For customers who want to virtualize existing EMC, HP, Hitachi, and NetApp E-Series storage arrays, which feature is required?

A customer is designing a FlexPod environment and is preparing for an ESXI host installation. High availability is a requirement for the FlexPod design. The ESXI servers will be bu...

Which two statements are true about VXLAN configured on Cisco Nexus 9000 Series switches operating in NX-OS mode? (Choose two.)

You are designing a FlexPod configuration with the Red Hat Enterprise Linux OpenStack platform. What is the OpenStack compute service for virtual machine management?

You are configuring Cisco UCS servers for Fibre Channel SAN boot and want to perform zoning on your Cisco Nexus 5000 series switches. Which statement is correct in this scenario?

You are building a new FlexPod solution and want to verify that you have cabled all the components according to FlexPod design best practices prior to putting your solution into pr...

A customer wants to design virtual machines provisioned across their VMware vSphere cluster. They need to leverage resource sharing and load balancing of their virtual machines. Wh...

Which port type would you configure when you connect a chassis to the Fabric Interconnects?

A customer is designing a FlexPod with VMware 6.0 in a SAN boot environment using FCoE. The customer has pre-determined the WWPN values for the NetApp LIFs and the UCS vHBAs. The c...

What are three ways to configure a UCS 5108 server chassis power supply? (Choose three.)

According to FlexPod CVDs, what is the recommended MTU size for iSCSI logical interfaces (LIFs) on the NetApp Storage Virtual Machine (SVM)?

View the Exhibit. A customer wants to ensure that FlexPod Datacenter connections to the storage layer are highly available. Which two configurations shown in the exhibit satisfy th...

An administrator decides to connect storage directly to the UCS Fabric Interconnect to support FCoE within a FlexPod configuration. In this scenario, which port type should be defi...

You are designing a new FlexPod-based data center and configuring Virtual Port Channels (vPC) to provide the highest bandwidth throughput, link, and device resiliency to each of yo...

You want to ensure minimal disruption to the UCS fabric in the case of a port failure between the blade chassis and the Fabric Interconnects of your FlexPod configuration. Which in...

You are asked to build a FlexPod solution using Application Centric Infrastructure (ACI). What are two ways to address the network requirements for high availability in this scenar...

What is the maximum number of chassis supported under a single UCS Manager domain?

You want to ensure optimum Layer 2 latency and performance for server-to-server communications when configuring high availability for bare-metal operating systems. In this scenario...

Which high-availability feature is supported by FlexPod with Unified Computing System Mini (UCS Mini) in a single chassis?

FlexPod Datacenter with Cisco UCS Mini supports which Fabric Interconnect model?

You are designing a FlexPod Express solution based on VMware for a customer that requires both SAN boot and VM datastores up to 100 TB in size. Which configuration would satisfy th...