NS0-170 Exam Questions
212 real NS0-170 exam questions with expert-verified answers and explanations. Page 2 of 5.
- Question #51
One of the items below cannot be set for NetCache authentication groups, which one is it?
- Question #52
State whether the following statement is true or false. Disk ID is represented in x.y format, where x refers to the host adaptor and y refers to the disk ID number.
- Question #53
Which of the following are supported interface types?
- Question #54
For which of the following would the "NTLM Cache" feature normally be used?
- Question #55
State whether the following statement is true or false. A packet trace captured by the NetCache can capture traffic to/from a specific IP address.
- Question #56
One of the below object types cannot run a cache, which one is it?
- Question #57
One of the below NetCache appliances maximum storage capacity is 504G Bytes, which of the following is it?
- Question #58
What occurs on the NetCache once you enable DNS caching?
- Question #59
State whether the following statement is true or false. To enable the NetCache appliance to load balance between a pool of Web servers you must specify the server IP addresses in t...
- Question #60
State whether the following statement is true or false. The backup/restore option in the Maintenance section of the Appliance Manager can possibly be used to restore and backup fil...
- Question #62
One of the access methods below will maintain boot messages right across all reboots, which one is it?
- Question #63
Once created and is successfully running, it is possible that NetCache groups be edited to revise names, permissions, orACLs. State whether the above statement is true or false
- Question #64
Which of the following commands would you make use of to view the available options for the showing config.http.acl command?
- Question #65
The default hierarchy wholly consists of a child and a parent in NetCache where the parent in the NetCaches has an option of being in a cluster configuration. State whether the abo...
- Question #66
Which of the following options shows the most accurate average response time shown in many different NetCache statistical displays?
- Question #67
State whether the following statement is true or false. In a forward proxy deployment, the NetCache appliance is normally installed close to the end user and administered by the se...
- Question #68
What command displays routing tables for NetCache appliances?
- Question #69
The correct manner in which to open a Network Appliance support ticket is to ____ at the NOW site?
- Question #70
Through which of the following requests cant the Browser be directed to the NetCache?
- Question #71
State whether the following statement is true or false. The NOW site holds data maintained by the Network Appliance. This information consists of records and customer product infor...
- Question #72
Which of the following must you successfully specify when configuring the NTLM authentication?
- Question #73
In which of the following sites can a complete list of Network Appliance support centers be found?
- Question #75
How would you know when the NetCache logs switched?
- Question #76
The NetCache appliance cannot be used for which of the following?
- Question #77
When would the ideal time to use the NetCache DNS Tree Search option?
- Question #78
Which of the following commands are used for running automated diagnostic analysis routines?
- Question #79
What is the traceroute command used for?
- Question #80
Which two of the following functions can the NetCache appliance's clock carry out?
- Question #81
What must be done in order to add a user to the appliance database, which two of the following you must enter?
- Question #82
Which of the following actions must you take in order to reach the NetCache firmware prompt ("OK prompt")?
- Question #83
Two of the below statements are untrue. Select them.
- Question #84
State whether the following statement is true or false. A multi-mode VIF merges two physical interfaces together where traffic is then active on both of the physical interfaces.
- Question #85
Two of the below options will not be added to the Autosupport message if NetCache Autosupport has been configured to show minimal detail, which two is it?
- Question #86
One of these NetCache Utility features is capable of capturing packets that are currently in the process of arriving or leaving via the network interfaces, which one is it?
- Question #87
Which of the following options best describes what the configure "Shared User Hosts" feature that is found under Appliance Manager's Setup > FTP > Caching Behavior is used for?
- Question #89
Which of the following options log only reports displays Web request data?
- Question #90
Two of the below statements are exactly the same? Choose the two.
- Question #91
Which of the following commands allows the NetCache interface configuration to be viewed?
- Question #92
Which of the following syntaxes are used to receive extensive help definition for particular commands?
- Question #93
Which method can be used to manage the NetCache appliances but can't be used to access the Command Line Interface (CLI)?
- Question #94
Which of the following does the NetCache not use when sending a packet beyond the local area network?
- Question #95
Which of the following would be the default HTTP proxy port on the NetCache?
- Question #96
State whether the following statement is true or false. The sysstat command allows the performance statistics to be viewed, which consists of the present CPU usage, the full amount...
- Question #97
State whether the following statement is true or false. When configured as an accelerator, the NetCache appliances are typically stationed near the server.
- Question #98
State whether the following statement is true or false. All defective parts require a RMA before to sending the product to Network Appliance.
- Question #99
What would be the reason for one using the NetCache Appliance Manager's Maintenance > Software > Error Pages feature?
- Question #100
Which two resources should be used by the NetCache to successfully build its routing table?
- Question #101
State whether the following statement is true or false. The NetCache appliances use RAID 4 with 1 parity disk and 1 or more disk for data purposes only.
- Question #102
How can the Network Appliance field alerts be received?
- Question #103
One of the services below cannot be categorized as a service supported by ICAP, which option is it?