Network_Appliance
NS0-162 · Question #84
A company has three servers that are using the iSCSI protocol to connect to a 2 node NetApp ONTAP cluster. The server administrator notices that half of the paths are down. When you check the ONTAP…
The correct answer is A. Verify that the UFs are up. B. Verify that the ISCSI data protocol has been enabled on the ports. See the full explanation below for the reasoning.
Question
A company has three servers that are using the iSCSI protocol to connect to a 2 node NetApp ONTAP cluster. The server administrator notices that half of the paths are down. When you check the ONTAP cluster, you notice that the servers are togging into only the first controller. Referring to the exhibit, which two steps do you take to troubleshoot the issue? (Choose two.)
Options
- AVerify that the UFs are up.
- BVerify that the ISCSI data protocol has been enabled on the ports.
- CVerify that each server has been rebooted.
- DVerify that the controller has not been taken over.
How the community answered
(30 responses)- A73% (22)
- C17% (5)
- D10% (3)
Community Discussion
No community discussion yet for this question.