Juniper
JN0-692 · Question #47
R1 and R2 are IS-IS Level 1 routers, but are not forming an adjacency. Which two reasons would account for this happening? (Choose two.)
The correct answer is B. The remote router does not have family iso enabled on its interface, D. The remote router is not configured to participate in the same Level 1 area. See the full explanation below for the reasoning.
Question
R1 and R2 are IS-IS Level 1 routers, but are not forming an adjacency. Which two reasons would account for this happening? (Choose two.)
Options
- AThe remote router is configured for both IPv4 and IPv6.
- BThe remote router does not have family iso enabled on its interface,
- CThe remote router does not have family clns enabled on its interface.
- DThe remote router is not configured to participate in the same Level 1 area
How the community answered
(45 responses)- A9% (4)
- B78% (35)
- C13% (6)
Community Discussion
No community discussion yet for this question.