Juniper
JN0-692 · Question #34
Click the Exhibit button. You are troubleshooting an interface where there are reports that ge-2/1/0 is not able to use more than 50% of its full bandwidth. According to the output shown in the…
The correct answer is C. There is a 500 Mbps shaping rate configured. See the full explanation below for the reasoning.
Question
Click the Exhibit button. You are troubleshooting an interface where there are reports that ge-2/1/0 is not able to use more than 50% of its full bandwidth. According to the output shown in the exhibit, which statement correctly describes the cause of this problem?
Exhibit
Options
- AThe exp-default classifier is in use on the interface.
- BThe input queues are using the default scheduler.
- CThere is a 500 Mbps shaping rate configured.
- DThe interface supports eight queues but is only using four queues.
How the community answered
(69 responses)- A12% (8)
- B3% (2)
- C80% (55)
- D6% (4)
Community Discussion
No community discussion yet for this question.