Juniper
JN0-691 · Question #12
What are two configuration steps required when performing a local loopback on an Ethernet interface? (Choose two.)
The correct answer is B. Use the interfaces <interface-name> ether-options loopback command. D. Use the set interfaces <interface-name> unit <logical-unit-number> family inet address <address>. See the full explanation below for the reasoning.
Question
What are two configuration steps required when performing a local loopback on an Ethernet interface? (Choose two.)
Options
- AUse the set interfaces <interface-name> mtu command.
- BUse the interfaces <interface-name> ether-options loopback command.
- CUse the set interfaces <interface-name> clocking internal command.
- DUse the set interfaces <interface-name> unit <logical-unit-number> family inet address <address>
How the community answered
(42 responses)- A17% (7)
- B76% (32)
- C7% (3)
Community Discussion
No community discussion yet for this question.