Click the Exhibit button. Connections between hosts connected to Leaf-1 and Leaf-2 are not working correctly. Referring to the exhibit, which two configuration changes are required to solve the…

Question

Exhibit

Options

• AConfigure the set switch-options vtep-source-interface irb.0 parameter on Leaf-
• BConfigure the set switch-options vrf-target target:65000:1 parameter on Leaf-2.
• CConfigure the set switch-options route-distinguisher 192.168.100.50:1
• DConfigure the set switch-options service-id 1 parameter on Leaf-2.

• A
  9% (4)
• B
  76% (34)
• C
  16% (7)

Explanation

Configure the set switch-options vrf-target target:65000:1 parameter on Leaf-2: The vrf- target parameter on Leaf-2 must match the vrf-target on Leaf-1 to ensure that both leaves use the same routing information for their respective VRFs. In the configuration, Leaf-1 has vrf-target target:65000:1, while Leaf-2 has vrf-target target:65000:2. These must be consistent to allow proper communication and routing between the leaves. Configure the set switch-options service-id 1 parameter on Leaf-2: The service-id configuration should be consistent across all leaf nodes to ensure that they are part of the same VXLAN service. Leaf-1 is configured with service-id 1, so Leaf-2 should be configured with the same service-id 1 to ensure consistency in the VXLAN deployment.

No community discussion yet for this question.