Juniper
JN0-682 · Question #58
Your colleague has begun working on the base configuration for an active-active multihomed EVPN connection shown in the exhibit. Which two actions will ensure a successful implementation? (Choose…
The correct answer is A. Change the ESI mode on PE2 to all-active. See the full explanation below for the reasoning.
Question
Your colleague has begun working on the base configuration for an active-active multihomed EVPN connection shown in the exhibit. Which two actions will ensure a successful implementation? (Choose two.) Exhibit:
PE1
set interfaces ge-0/0/4 vlan-tagging
set interfaces ge-0/0/4 encapsulation flexible-
ethernet-services
set interfaces ge-0/0/4 esi
00:00:00:00:00:00:00:00:00
set interfaces ge-0/0/4 esi all-active
set interfaces ge-0/0/4 unit 0 encapsulation
vlan-bridge
set interfaces ge-0/0/4 unit 0 vlan-id 300
PE2
set interfaces ge-0/0/4 vlan-tagging
set interfaces ge-0/0/4 encapsulation flexible-
ethernet-services
set interfaces ge-0/0/4 esi
00:22:44:66:88:00:22:44:66:88
set interfaces ge-0/0/4 esi single-active
set interfaces ge-0/0/4 unit 0 encapsulation
vlan-bridge
set interfaces ge-0/0/4 unit 0 vlan-id 300
Options
- AChange the ESI mode on PE2 to all-active
- BChange the ESI mode on PE1 to signal-active
- CChange the ESI value on the PE1 device to 00.22.44.88.00.22.44.66.88
- DChange the ESI value on the PE2 device to 00.00.00.00.00.00.00.00.00
How the community answered
(36 responses)- A75% (27)
- B14% (5)
- C3% (1)
- D8% (3)
Community Discussion
No community discussion yet for this question.