Juniper
JN0-649 · Question #85
Click the Exhibit. You have just configured on an OSPF adjacency between two routers. After you commit the configuration, you notice that your adjacency is not up. Referring to the exhibit, what…
The correct answer is C. You must configure on interface-type o n R2. See the full explanation below for the reasoning.
Question
Click the Exhibit. You have just configured on an OSPF adjacency between two routers. After you commit the configuration, you notice that your adjacency is not up. Referring to the exhibit, what would cause the problem?
Exhibits
Options
- AYou must configure lo on R2.
- BYou must configure hello and dead intervals on R1.
- CYou must configure on interface-type o n R2.
- DYou must configure bfd on R2.
How the community answered
(37 responses)- A5% (2)
- B5% (2)
- C76% (28)
- D14% (5)
Community Discussion
No community discussion yet for this question.