Juniper
JN0-649 · Question #69
You are troubleshooting an OSPF adjacency issue between R1 and R2. What is the reason for the ExStart state shown in the exhibit?
The correct answer is C. R1 and R2 are using the same IP address. See the full explanation below for the reasoning.
Question
You are troubleshooting an OSPF adjacency issue between R1 and R2. What is the reason for the ExStart state shown in the exhibit?
Exhibit
Options
- AR2 was elected as the designated router.
- BR1 was elected as the backup designated router.
- CR1 and R2 are using the same IP address.
- DThe MTU is not the default on R1 and R2.
How the community answered
(17 responses)- B12% (2)
- C82% (14)
- D6% (1)
Community Discussion
No community discussion yet for this question.