Juniper
JN0-648 · Question #57
You recently implemented the configurations shown in the exhibit. After committing these changes, the community devices connected to AS-1 are not able to communication with the appropriate community…
The correct answer is C. You must configure the ge-0/0/1 interface on both switches the inter-switch links. See the full explanation below for the reasoning.
Question
You recently implemented the configurations shown in the exhibit. After committing these changes, the community devices connected to AS-1 are not able to communication with the appropriate community devices connected to AS-2. What must be to allow these community devices to communicate?
Exhibit
Options
- AYou must configure to allow the ge-0/0/1 interface on AS-1 as the inter-switch.
- BYou must configure the ge-0/0/10 interface on AS-1 as the inter-switch link.
- CYou must configure the ge-0/0/1 interface on both switches the inter-switch links.
- DYou must configure an isolation VLAN ID under the vlan-pri vlan on the AS-2 switch.
- EYou must configure an isolation VLAN ID under the vlan-pri VLAN on both switches.
How the community answered
(22 responses)- A9% (2)
- B5% (1)
- C82% (18)
- E5% (1)
Community Discussion
No community discussion yet for this question.