JN0-647 Exam Questions

Which router ID is correct for OSPFv3?

Which type of BGP is used to peer with a different autonomous system?

Click the Exhibit. Referring to the exhibit, what is the minimum number of MSTP regions where the topology would be implemented?

Click the Exhibit. You are asked to advertise the 1.0.0.0/8 and 1.5.5.5/32 routes to your 10.254.32.2 BGP peer. Referring to the exhibit, which configuration change would satisfy t...

Which protocol is used for port level access control and authentication?

Referring to the exhibit, which two actions would solve this problem? (Choose two)

When configuring class of service, what would you use to allocate bandwidth to a forwarding class?

A packet enters the router and is subject to ingress's processing. In which order is the packet processed?

Click the Exhibit. Referring to the exhibit which two statements are true? (Choose two.)

Click the Exhibit. Which AS path matches the AS path regular expression shown in the exhibit?

A new PoE+VoIP handset was added to an EX Series device. The handset is experiencing connectivity issues. The EX Series device's committed configuration includes the set poe interf...

Click the Exhibit. A customer is concerned that the route damping policy on routes with prefixes greater than/17 is allowing too many flaps to occur. The customer does not want to...

Click the Exhibit. Referring to the exhibit, you have EBGP peerings with both ISP1 and ISP2. You are receiving the 172.25.12.0/24, 172.25.13.0/24, 172.25.14.0/24, and 172.25.15.0/2...

Which protocol is used for port-level access control and authentication?

Click the Exhibit. Referring to the exhibit, you are receiving multiple routes from ISP3 through two EBGP neighbors. You must ensure that all traffic leaving R1 destined to the net...

Click the Exhibit. Referring to the exhibit, which two statements are correct? (Choose two.)

Click the Exhibit. You are configuring dynamic rendezvous points for your PIM multicast domain. You have chosen to use auto-RP as the dynamic RP mechanism. You are not seeing the a...

OSFP is stuck in the ExStart state. What is a common cause of this problem?

Click the Exhibit. Referring to the exhibit, Area 1 is a stub area. Which two statements are correct in this scenario? (Choose two.)

Click the Exhibit. You have three switches, each with a trunk connection allowing all VLANs to the switches. CIST will coverage, however MSTP will not. Referring to the exhibit, wh...

Which three statements are true about strict-high priority queues? (Choose three.)

Click the Exhibit. Router1, in peer AS 65001, advertises routes to R2 using EBGP. R2 advertises the routes learned from R1 to R3 using IBGP. R3 is configured as a route reflector w...

Which two statements are true about 802.1Z dynamic filters based on RADUIS attributes? (Choose two.)

Which protocol is a multicast routing protocol?

You are configuring a scheduler map on an EX9200 Series device. You want to ensure that traffic is dropped in a policing action once traffic exceeds the configured transit rate. Wh...

Click the Exhibit. All of the clients attached to your EX4300 report that authentication to the network is abnormally slow. While troubleshooting, you individually test the RADIUS...

You are enabling 802.1X authentication on an EX Series device. You are configuring the switch in the conference room where you will have non-employees with devices that do not supp...

Which two statements are true about OSPFv3? (Choose two.)

Computers on the network are assigned IP addresses from DHCP server based on the MAC address of the computer. The network administrator wants computes assigned to a VLAN using the...