Juniper
JN0-636 · Question #69
When would you use the port-overloading-factor 1 setting?
The correct answer is B. to disable the port-overloading. See the full explanation below for the reasoning.
Question
When would you use the port-overloading-factor 1 setting?
Options
- Ato enable the port-overloading
- Bto disable the port-overloading
- Cto map ports with 1:1 ratio for port-overloading
- Dto set the maximum port-overloading capacity to 65,536
How the community answered
(30 responses)- A13% (4)
- B80% (24)
- C3% (1)
- D3% (1)
Community Discussion
No community discussion yet for this question.