Juniper
JN0-636 · Question #44
You have already configured a hub-and-spoke VPN with one hub device and two spoke devices. However, the hub device has one neighbor in the Init state and one neighbor in the Full state. What would…
The correct answer is B. Configure the st0.0 interface under OSPF as a point-to-multipoint interface. See the full explanation below for the reasoning.
Question
You have already configured a hub-and-spoke VPN with one hub device and two spoke devices. However, the hub device has one neighbor in the Init state and one neighbor in the Full state. What would you do to resolve this problem?
Options
- AConfigure the st0.0 interface under OSPF as a nonbroadcast multiple access interface.
- BConfigure the st0.0 interface under OSPF as a point-to-multipoint interface.
- CConfigure the st0.0 interface under OSPF as a point-to-point interface.
- DConfigure the st0.0 interface under OSPF as an unnumbered interface.
How the community answered
(68 responses)- A10% (7)
- B84% (57)
- C4% (3)
- D1% (1)
Community Discussion
No community discussion yet for this question.