Juniper
JN0-633 · Question #147
You have configured an IPsec VPN with traffic selectors; however, your IPsec tunnel does not appear to be working properly. What are two reasons for the problem? (Choose two.)
The correct answer is A. You are configured a remote address value of 0.0.0.0/0. B. You are trying to use traffic selectors with policy-based VPNs. See the full explanation below for the reasoning.
Question
You have configured an IPsec VPN with traffic selectors; however, your IPsec tunnel does not appear to be working properly. What are two reasons for the problem? (Choose two.)
Options
- AYou are configured a remote address value of 0.0.0.0/0.
- BYou are trying to use traffic selectors with policy-based VPNs.
- CYou have configured 15 traffic selectors on each SRX Series device.
- DYou are trying to use traffic selectors with route-based VPNs.
How the community answered
(46 responses)- A76% (35)
- C15% (7)
- D9% (4)
Community Discussion
No community discussion yet for this question.