JN0-533 Exam Questions
120 real JN0-533 exam questions with expert-verified answers and explanations. Page 3 of 3.
- Question #101
When a new session is created on the primary ScreenOS device, what are two results that happen on the backup device? (Choose two.)
- Question #102
Which two statements are true about redundant interfaces on a ScreenOS device? (Choose two.)
- Question #103
Which two protocols are used for NSRP IP tracking? (Choose two.)
- Question #104
Which three types of status can a member of an NSRP cluster have? (Choose three.)
- Question #105
Which two configuration elements are synchronized between the members of an NSRP cluster? (Choose two.)
- Question #106
The master device in an NSRP cluster experiences an interface failure on a monitored interface. By default, what happens as a result of this failure?
- Question #107
What are three valid states for an NSRP member? (Choose three.)
- Question #108
While troubleshooting performance issues on your NetScreen cluster, you decide to failover the master device to its redundant peer. Which two methods will accomplish this task? (Ch...
- Question #109
You have been making changes on an NSRP cluster and find that the ScreenOS devices are out of sync. You want to synchronize the devices' configurations together. Which command and...
- Question #110
A monitored interface on a clustered pair of ScreenOS devices goes down and both devices became ineligible to be master of the cluster. As a result, neither device is passing traff...
- Question #111
You have entered the command set ffilter src-ip 1.1.7.250 dst-ip 10.1.10.5 ip-prot 6 Juniper JN0-533 Exam What will be the resulting output in the debug for which this was created?
- Question #112
You have configured a secondary path for the NSRP cluster. Which type of traffic is sent over the secondary path?
- Question #113
When using NSRP, which command will insure uninterrupted communications for VPNs using certificates for authentication?
- Question #114
You have configured NSRP so that session state messages are sent to the backup device. A session is about to timeout on the backup device. Which statement most correctly describes...
- Question #115
Juniper JN0-533 Exam You are creating a DIP pool of 30 addresses. You would like to see how addresses are being allocated to different traffice streams. Which command will you use...
- Question #116
You are using NSRP and enable preempt on a device with a priority of 120. The other device has the default priority set. What will be the result of this action?
- Question #117
You enter the following commands: snoop filter ip dst-ip 1.1.1.10 snoop filter ip src-ip 2.1.1.10 What is the net result of these settings?
- Question #118
What will happen if you type the command unset protocol vrouter trust-vr protocol ospf?
- Question #119
During main mode negations a failure has occurred while using IKE certificates. Which message pair would you review to troubleshoot this failure?
- Question #120
You have entered the following BGP configuration: set vrouter trust-vr bgp 65530 set vrouter trust-vr bgp enable set vrouter trust-vr protocol bgp neighbor 1.1.1.250 remote-as 6550...