In Juniper Apstra. which three modes are available for devices? (Choose three.)

The correct answer is A. Deploy D. Drain E. Ready. Juniper Apstra supports three deploy modes for devices: Deploy, Drain, and Ready. These modes determine the configuration and state of the devices in the data center fabric. Deploy: This mode applies the full Apstra-rendered configuration to the device, according to the Apstra…

Orchestration and Automation

Question

Options

ADeploy
BActive
CStopped
DDrain
EReady

How the community answered

(44 responses)

A
73% (32)
B
9% (4)
C
18% (8)

Explanation

Juniper Apstra supports three deploy modes for devices: Deploy, Drain, and Ready. These modes determine the configuration and state of the devices in the data center fabric. Deploy: This mode applies the full Apstra-rendered configuration to the device, according to the Apstra Reference Design. The device state becomes IS-ACTIVE and the device is ready to carry traffic in the fabric. Drain: This mode adds a "drain" configuration to the device, which prevents any new traffic from entering the device. The device state becomes IS-READY and the device is prepared for maintenance or decommissioning. Ready: This mode removes the Apstra-rendered configuration from the device, leaving only the basic configuration such as device hostname, interface descriptions, and port speed/breakout. The device state becomes IS-READY and the device is not part of the fabric.

Topics

#device modes#Deploy#Drain#Juniper Apstra

Community Discussion

No community discussion yet for this question.

Full JN0-480 Practice