Using Juniper Apstra. which component is defined in a template?

Question

Options

• Athe leaf-to-spine interconnection
• Bthe speed of the links between the spine devices and the leaf devices
• Cthe number of spine devices in a topology
• Dthe definition of IP pools

• A
  79% (26)
• B
  6% (2)
• C
  3% (1)
• D
  12% (4)

Explanation

A template is a configuration template that defines a network's policy intent and structure. A template can be either rack-based or pod-based, depending on the type and number of racks and pods in the network design. A template includes the following details: Policies: These are the parameters that apply to the entire network, such as the overlay control protocol, the ASN allocation scheme, and the underlay type. Structure: This is the physical layout of the network, such as the type and number of racks, pods, spines, and leaves. The structure also defines the leaf-to-spine interconnection, which is the number and type of links between the leaf and spine devices. The leaf-to-spine interconnection can be either single or dual, depending on the redundancy and bandwidth requirements. Therefore, the correct answer is A. the leaf-to-spine interconnection. This is a component that is defined in a template, as it determines the physical connectivity of the network. The speed of the links, the number of spine devices, and the definition of IP pools are not components that are defined in a template, as they are either derived from the device profiles, the resource pools, or the blueprint settings.

No community discussion yet for this question.