Juniper
JN0-370 · Question #61
After configuring OSPF between two routers you check for an adjacency. You see that the adjacencies are not coming up on an Ethernet segment. What are two reasons that would cause this situation?…
The correct answer is A. You have a mismatched IP subnet/mask B. Your hello timer intervals are mismatched. See the full explanation below for the reasoning.
Question
After configuring OSPF between two routers you check for an adjacency. You see that the adjacencies are not coming up on an Ethernet segment. What are two reasons that would cause this situation? (Choose two) Juniper JN0-370 Exam
Options
- AYou have a mismatched IP subnet/mask
- BYour hello timer intervals are mismatched
- CYou are not using the same Junos version on each side
- DYou priority values are mismatched
How the community answered
(37 responses)- A78% (29)
- C8% (3)
- D14% (5)
Community Discussion
No community discussion yet for this question.