Juniper
JN0-370 · Question #242
You are troubleshooting latency on a Node device on your QFabric system and discover a Layer 2 loop. What would cause this behavior?
The correct answer is B. A switch was attached to both nodes in a redundant server Node group. See the full explanation below for the reasoning.
Question
You are troubleshooting latency on a Node device on your QFabric system and discover a Layer 2 loop. What would cause this behavior?
Options
- ASTP was disabled on the Interconnect devices.
- BA switch was attached to both nodes in a redundant server Node group.
- CData center bridging was disabled on the affected Node device.
- DThe fabric administrator is unresponsive.
How the community answered
(28 responses)- A7% (2)
- B71% (20)
- C7% (2)
- D14% (4)
Community Discussion
No community discussion yet for this question.