Juniper
JN0-370 · Question #227
A customer mentions that a new Node device connected to a QFabric system is not discovered. What are three reasons for this issue? (Choose three.)
The correct answer is A. The control plane cabling is incorrect. C. The Node device is in standalone mode. E. The VCCP protocol on the Node device is not running. See the full explanation below for the reasoning.
Question
A customer mentions that a new Node device connected to a QFabric system is not discovered. What are three reasons for this issue? (Choose three.)
Options
- AThe control plane cabling is incorrect.
- BThe C0 and C1 ports on the Node device are not assigned correct IP addresses.
- CThe Node device is in standalone mode.
- DThe Node device is not preconfigured in the QFabric system.
- EThe VCCP protocol on the Node device is not running.
How the community answered
(41 responses)- A76% (31)
- B7% (3)
- D17% (7)
Community Discussion
No community discussion yet for this question.