Juniper
JN0-370 · Question #225
A customer says that a Node device in a Node group that had been working was suddenly disconnected from the QFabric system. Which two commands should you use to troubleshoot the problem? (Choose two.)
The correct answer is B. Use show log messages on the Node device. C. Use show virtual-chassis protocol adjacency provisioning on the Node group. See the full explanation below for the reasoning.
Question
A customer says that a Node device in a Node group that had been working was suddenly disconnected from the QFabric system. Which two commands should you use to troubleshoot the problem? (Choose two.)
Options
- AUse show virtual-chassis status on the fabric administrator.
- BUse show log messages on the Node device.
- CUse show virtual-chassis protocol adjacency provisioning on the Node group.
- DUse show fabric administration inventory infrastructure on the fabric administrator.
How the community answered
(24 responses)- A13% (3)
- B79% (19)
- D8% (2)
Community Discussion
No community discussion yet for this question.