Juniper
JN0-370 · Question #142
You run the command show interfaces terse ge-1/0/0 and see the output shown in the exhibit. Why are two addresses being shown for this interface? user@r1> show interfaces terse ge-1/0/0 Interface…
The correct answer is C. The two addresses being seen are the link-local and site-local. See the full explanation below for the reasoning.
Question
You run the command show interfaces terse ge-1/0/0 and see the output shown in the exhibit. Why are two addresses being shown for this interface? user@r1> show interfaces terse ge-1/0/0 Interface Admin Link Proto Local Remote ge-1/0/0 up up ge-1/0/0.0 up up inet6 fe80::226:88ff:fe02:7481/64 fec0:0:0:2003::1/64
Options
- ATwo addresses are assigned in IPv6, one for the physical and one for the logical interface.
- BTwo addresses are seen because the loopback address of the router is associated with the interface.
- CThe two addresses being seen are the link-local and site-local.
- DAn IPv6 address conflict is being seen; verify your interface configuration for problems.
How the community answered
(35 responses)- A6% (2)
- B11% (4)
- C80% (28)
- D3% (1)
Community Discussion
No community discussion yet for this question.