JN0-370 Exam Questions

Node devices provide which three connectivity functions on QFabric systems? (Choose three.)

Which three improvements does the QFabric system provide over legacy data center environments? (Choose three.)

Director devices within a QFabric system provide which three redundant hardware components? (Choose three.)

Which two Juniper switch models would you use as Node device components of a QFabric system? (Choose two.)

A QFX3000-G QFabric system supports up to how many Interconnect devices? Juniper JN0-370 Exam

Which QFabric system component behaves like a backplane on a traditional switch?

A customer wants to upgrade an existing data center to use a QFabric system. What are two primary benefits for doing this? (Choose two.)

Which two interface naming conventions are correct for QFabric systems? (Choose two.)

You are preparing to perform the initial setup of the Director group. How many IP addresses are required for the management network?

Which two groups in a QFabric system support link aggregation interfaces? (Choose two.)

Referring to the output shown in the exhibit, which two statements are correct? (Choose two.) Click the Exhibit to view.

Referring to the exhibit, a customer noticed that one of the QFX3008 devices failed to reboot in a maintenance window. When troubleshooting the issue, what should the customer do?...

Spanning Tree Protocol BPDUs can only be processed by which QFabric system group?

What are three common Layer 2 connections on a OFabric system? (Choose three.)

Juniper JN0-370 Exam Which two statements are true for the system shown in the exhibit? (Choose two.) Click the Exhibit to view. Juniper JN0-370 Exam

You are asked to provide redundant paths between a server and a QFabric system. Which two connection types would you use? (Choose two.)

Referring to the exhibit, which two statements are true? (Choose two.) Juniper JN0-370 Exam

An administrator suspects that a duplicate MAC address on the same VLAN is causing connectivity problems for a host. Which command helps the administrator determine which ports are...

What is the maximum number of member links for a link aggregation group associated with the network Node group?

You have been asked to configure Layer 3 interfaces in a newly deployed QFabric system. Which consideration should you follow?

You are informed that a server in VLAN Blue cannot communicate with a server in VLAN Red. The QFabric system is providing gateway services for the attached VLANs. What must be veri...

The server administrator has reported a connectivity issue between Server A and Server B, which belong to the VLANs v10 and v20 respectively. Both servers are connected to the netw...

What are two limitations of direct attached storage (DAS) within the data center? (Choose two.)

Which two storage protocols are supported by a QFabric system? (Choose two.)

What is a function of enhanced transmission selection (ETS) within a QFabric system?

Which statement is true about data center bridging?

You are asked to enable Fibre Channel over Ethernet (FCoE) on a QFabric system. Which two CLI commands would you use to configure this? (Choose two.)

You configured your QFabric system as an FCoE transit switch and FCoE traffic is not passing between a server and your FCoE gateway. What are two possible reasons for the traffic l...

Referring to the exhibit, which data center bridging (DCB) standard is shown? Click the Exhibit to view.

Which two statements about BGP are accurate? (Choose two.)

Which two elements contribute to the bridge ID when configuring RSTP? (Choose 2) Juniper JN0-370 Exam

You want to influence how traffic enters your network. Using industry best practices, which two BGP attributes would you modify to accomplish this goal? (Choose two)

You have recently installed a second Routing Engine (RE) in your router. Which two statements correctly describe the expected behavior if the primary RE fails? (Choose two.)

Which command would you use to verify the presence of VPN routes on a PE device?

Which statement is true of a Layer 2 circuit?

Click the Exhibit button. An operator is unable to establish any IS-IS adjacencies on a router in the network. Based on the configuration shown in the exhibit, what is the problem?

What are three circumstances under which a router sends link-state PDUs (LSPs)? (Choose three)

In an RSTP network, which combination of port types can exist on the root bridge?

Your company has purchased two new Juniper Networks MX480 routers. Your manager has asked you to add these two devices to the existing ISIS network. Which two rules about ISIS adja...

In the evaluation of an RSTP configuration BPDU, which two values are contained in the Bridge ID value? (Choose two)

Under which Junos configuration hierarchy is a load-balancing policy applied? Juniper JN0-370 Exam

Which two configuration elements are defined under an MSTP instance? (Choose two)

Which protocol is used by wired Ethernet to manage frame collisions?

You have been asked to provision a service provider's network to accommodate Layer 3 VPNs as defined in RPC 4364. Which three tasks must be performed before the provider core is re...

You would like two LDP routers on opposite sides of your network to become neighbors. Which LDP message is used to form this relationship?

In which two environments would BGP add value? (Choose two)

Click the Exhibit button. Referring to the exhibit, which policy(s) will be applied to neighbor 172.18.4.5?

Click the Exhibit button. In the exhibit Router A and Router B are operating on the LAN with Router B acting as the designated intermediate system (DIS). When Router C and Router D...

You are logged into a router and issue the command show route protocol bgp. You see that you have received the route 10 0.4/24 from two different peers Both peers were learned usin...

How many equal-cost paths can be assigned to a single route in the Junos OS?