JN0-361 Exam Questions
115 real JN0-361 exam questions with expert-verified answers and explanations. Page 2 of 3.
- Question #51
Which two routing protocols make use of a designated router, or pseudo node, to represent a broadcast network? (Choose two.)
- Question #52
Click the exhibit. A customer has two VLANs to extend between Site-1 and Site-2. The customer does not want to route the VLANs or renumber the VLANs. Referring to the exhibit, whic...
- Question #53
Which three statements are true about GRES? (Choose three.)
- Question #54
Click the Exhibit. Referring to the exhibit, what is the result of applying this policy?
- Question #55
Which two statements are correct regarding TLVs in IS-IS? (Choose two.)
- Question #56
Click the Exhibit. Referring to the exhibit, which route(s) will be exported to neighbor 192.168.1.2?
- Question #57
Click the Exhibit. You have configured the IBGP group shown in the exhibit. However, committing your configuration fails. Which parameter should you add to the IBGP group configura...
- Question #58
What is the OSPFv3 router ID?
- Question #59
Click the exhibit. Referring to the exhibit, which configuration must be set on R2 to from a Level 1 IS-IS adjacency with R1?
- Question #60
A customer pays for the bandwidth on a per-packet basis. The network administrator wants to constrain costs and prevent Layer 2 loops on a multihomed Layer 2 WAN network. Which tec...
- Question #61
You asked to deploy a large-scale IS-IS network with multiple areas. In this scenario, which two statements are true? (Choose two.)
- Question #62
You are establishing RSVP LSPs through your MPLS-enabled network. You are asked to ensure that the LSPs will support end-to-end class-of-service handling. Which statement is correc...
- Question #63
Click the Exhibit. Referring to the exhibit, which IS-IS router will be selected as the DIS?
- Question #64
You are using RSVP to signal an MPLS LSP. Which statement is true in this scenario?
- Question #65
What is the correct simplification of the 2001:0000:0000:0234F:0000:CBFF:5CA1:A001 IPv6 address?
- Question #66
Click the Exhibit button. An interface is configured as shown in the exhibit. What must also be configured for this interface to participate in VLAN 100 and 200?
- Question #67
An Ethernet bridge is configured such that all interfaces are in a single broadcast domain By default. Which two tasks does the bridge perform in response to receiving a multicast...
- Question #68
Which configuration can be applied to ensure that no more than 600 MAC addresses are learned by a virtual switch?
- Question #69
You are logged into a PE router participating in a Layer 3 VPN as defined in RFC 4364. You would like to ping the remotely connected CE router's loopback address. The address of th...
- Question #70
Click the Exhibit button. You have two routers connected over a Gigabit Ethernet link as shown in the exhibit It is required that an IS-IS adjacency be established without the need...
- Question #71
Which two problems occur when increasing numbers of users are added to an Ethernet LAN with no switches present? (Choose two.)
- Question #72
Click the Exhibit button. In the exhibit, all routers are sending routes to Router B Which routes will be advertised from Router B to Router D?
- Question #73
Click the Exhibit button. Given the OSPF network topology shown in the exhibit, you would like to inject external (non- OSPF) routes into the network on Router D Which two OSPF are...
- Question #74
In your network, you have two LDP routers connected across four physical interfaces. You have also enabled LDP to operate on all four of those interfaces. What is the resulting out...
- Question #75
By default, which RSVP reservation style is used by the Junos OS?
- Question #76
Which three statements are true about BGP? (Choose three)
- Question #77
You observe that VPN routes are hidden on your PE router Which situation accounts for these hidden routes?
- Question #78
To prevent fragmentation issues across a GRE tunnel, which MTU value is recommended for the tunnel to accommodate most IP packets?
- Question #79
By default, which three criteria are used by the Junos load-balancing algorithm to determine a traffic flow? (Choose three.)
- Question #80
Click the Exhibit button. Based on the configuration shown in the exhibit, what will be the state of the IS-IS levels on interface ge-0/0/0.100?
- Question #81
Referring to the exhibit, which firewall filter action(s) will be applied to incoming frames to ge-1/0/3?
- Question #82
Click the Exhibit button. Given the OSPF topology shown in the exhibit, how many unique link-state databases are present in the network?
- Question #83
Click the Exhibit button. In the exhibit, three IPv6 addresses are listed. Which two statements are true? (Choose two.)
- Question #84
You have just configured IPv6 in your network. A packet arrives on your router that exceeds the MTU size. How will an IPv6 router respond?
- Question #85
Which two statements reflect benefits of performing per-flow load balancing over per-packet load balancing? (Choose two.)
- Question #86
By default, the Junos OS advertises which address(es) in LDP forwarding equivalency class (FEC) messages?
- Question #87
Click the Exhibit button. Two bridge domains are configured as shown in the exhibit. What must be configured as part of the ge-1/0/3 interface configuration to accept tagged frames...
- Question #88
What are three valid BGP message types? (Choose three.)
- Question #89
What are two benefits of using an OSPF designated router (DR)? (Choose two.)
- Question #90
Which three statements are true regarding the show system switchover operational mode command? (Choose three.)
- Question #91
You have been asked to use a convention that allows for auto configuration of interface addresses. You are not allowed to use DHCPv6. What do you do?
- Question #92
You notice that the RID of your router is being taken from the address of your management interface. What could cause this scenario?
- Question #93
You have been asked to identify what the contributing routes are for route 204.7.15/21.Which command will show this information?
- Question #94
Which packet type does the router use to request up-to-date link-state information?
- Question #95
Which forwarding table designation is used to indicate that load balancing is working correctly?
- Question #96
Which two statements are correct regarding VPLS mesh groups? (Choose two.)
- Question #97
Router A receives two similar route advertisements from different BGP peers.What would cause a route to be selected in this scenario?
- Question #98
Which two configuration elements must match on all switches participating in the same MSTP region? (Choose two.)
- Question #99
Click the Exhibit button. What does IS-IS/18 mean in the output displayed in the exhibit?
- Question #100
What are two characteristics of a traditional Ethernet LAN? (Choose two.)