Juniper
JN0-361 · Question #35
You are setting up a new IS-IS adjacency between two devices. The new Level1 adjacency is not establishing. What would cause this behavior?
The correct answer is B. The Level 1 routers have mismatched area IDs. See the full explanation below for the reasoning.
Question
You are setting up a new IS-IS adjacency between two devices. The new Level1 adjacency is not establishing. What would cause this behavior?
Options
- AThe routers support a minimum MTU of 1492 bytes.
- BThe Level 1 routers have mismatched area IDs.
- CThe router ID has not been explicitly configured.
- DThe IP addresses are on different subnets.
How the community answered
(20 responses)- A5% (1)
- B75% (15)
- C15% (3)
- D5% (1)
Community Discussion
No community discussion yet for this question.