JN0-360 Exam Questions

Which high availability feature allows uninterrupted packet forwarding and temporary suppression of all routing protocol updates?

You are using RSVP in your network to signal MPLS LSPs. You are asked to ensure that the egress MPLS router receives the full label stack, containing both the hop-by-hop and VPN la...

What are two ways to assign an IPv6 to an interface? (Choose two.)

What are two valid statements for virtual switches on MX Series devices? (Choose two.)

Click the Exhibit button. Referring to the exhibit, which two statements are correct? (Choose two.)

Click the Exhibit button. Referring to the exhibit, which static route will be exported into OSPF?

Click the Exhibit button. In the exhibit, which configuration is required to establish a single adjacency between the two IS- IS routers?

In an IS-IS network, Router A is the current DIS with a priority of 64. Router B comes online with a priority of 100. In this scenario, which statement is correct?

What is the role of the route distinguisher (RD) in a Layer 3 VPN?

Click the Exhibit button. An ISO NET has been configured on R2's lo0.0 interface and ge-0/0/2.0 has been configured to run IS-IS. However, IS-IS adjacency on ge-0/0/2.0 is not comi...

You are asked to deploy a large-scale IS-IS network with multiple areas. In this scenario, which statement is true?

In a Junos device functioning as an MPLS transit router, which routing table is used when performing a forwarding lookup for an incoming packet?

Click the Exhibit button. Referring to the exhibit, MED is being used in your BGP network. All other BGP configurations use the default settings. Which statement is correct regardi...

Click the Exhibit button. Referring to the exhibit, four IS-IS routers have been deployed on a multi- access Ethernet segment. Router C came online first. After all routers are onl...

For two switches to participate in the same Multiple Spanning Tree Protocol (MSTP) region, which three values must match? (Choose three.)

Click the Exhibit button. In the exhibit, R1 is sending the 172.16.100.0/24 route to R2 through EBGP. R2 has IBGP sessions to R3 and R4, but they are not installing the route. All...

What is the correct format for an IPv4 address mapped into IPv6?

You are deploying IS-IS in your network to enable the routing of only IPv6. Assume that the loopback interface has been properly configured. What is the minimum required configurat...

Your customer requests that you provide a transparent Layer 2 service between two of their remote locations. This service must allow the customer to pass tagged traffic from multip...

What are three IS-IS PDU types? (Choose three.)

You have three aggregate routes all with the same route preference. What is the second parameter used to determine the active route?

You are configuring a trunk interface on an MX Series device and want to ensure that any outgoing frames associated with VLAN 100 are transmitted as untagged frames. Which configur...

An RSVP enabled router receives an RSVP reservation message for a new RSVP path. The router is unable to accommodate the reservation request. Which action does the router take?

What are two valid protocols used to signal VPLS in a network? (Choose two.)

By default, which router in an MPLS LSP removes the MPLS header?

You are asked to deploy OSPF between two routers over a broadcast medium. Which three fields in the OSPF hello packet must match? (Choose three.)

Which three STP protection mechanisms are supported on MX Series, EX Series, and QFX Series devices? (Choose three.)

How are BGP routes originated?

What are two destination addresses used for OSPF link-state update packets? (Choose two.)

Which three statements are true about BGP default operations? (Choose three.)

Click the Exhibit button. Referring to the exhibit, which two statements are correct about R2? (Choose two.)

R1 is an OSPF router with a priority of 100 and has been elected as the designated router (DR). R2 is the backup designated router (BDR) with a priority of 50. A third router, R3,...

Your network runs RSTP and includes a LAN segment shared by two MX Series devices. The two MX Series devices sharing this LAN segment each have two connections on the shared segmen...

Your network consists of multiple remote locations using both IPv4 and IPv6. You have an IPv4- based Internet connection at each site provided by different, local service providers...

Click the Exhibit button. Which two statements are correct according to the output shown in the exhibit? (Choose two.)

You are asked to deploy OSPF between two routers over a point-to point link. Which three fields in the OSPF hello packet must match? (Choose three.)

Which statement is correct about OSPF Type 7 LSAs?

Which OSPF LSA type describes the router IDs of ASBR routers located in remote areas?

Referring to the exhibit, which two statements are correct? (Choose two.)

What are three well-known mandatory BGP attributes? (Choose three.)

Your customer requests that you provide a transparent Layer 2 service between two of their remote locations. This service must allow the customer to pass tagged traffic from multip...

In an RSVP-based MPLS network, which ERO type specifies the exact order of routers through which an LSP must travel, without consulting the IGP?

You are adding IPv6 to an existing IPv4 network running OSPF. Your plan is to use OSPFv3 to route both IPv4 and IPv6 prefixes. Which configuration will enable OSPFv3 to advertise p...

How many bytes does IP-IP tunneling add to an IP packet?

An IS-IS router on a broadcast medium has detected its LSDB is missing an LS PDU. Which action will the router take?

An IS-IS TLV includes which two attributes? (Choose two.)

Which two statements are true regarding the output shown in the exhibit? (Choose two.)

Which two LSA types would an ABR generate and send into a totally stubby area? (Choose two.)

Which statement about Rapid Spanning Tree Protocol (RSTP) is correct?

Which statement is true about VSTP?