Juniper
JN0-360 · Question #92
You notice that the RID of your router is being taken from the address of your management interface. What could cause this scenario?
The correct answer is C. A suitable loopback address was not configured on the router. See the full explanation below for the reasoning.
Question
You notice that the RID of your router is being taken from the address of your management interface. What could cause this scenario?
Options
- AThe loopback address was configured with a /32 address.
- BThe loopback address was not configured under [edit protocols ospf].
- CA suitable loopback address was not configured on the router.
- DThe loopback address was configured under [edit routing-options].
How the community answered
(23 responses)- A4% (1)
- B13% (3)
- C74% (17)
- D9% (2)
Community Discussion
No community discussion yet for this question.