Juniper
JN0-360 · Question #158
You run the command show interfaces terse ge-1/0/0 and see the output shown in the exhibit. Why are two addresses being shown for this interface? user@r1> show interfaces terse ge-1/0/0 Interface…
The correct answer is C. The two addresses being seen are the link-local and site-local. See the full explanation below for the reasoning.
Question
You run the command show interfaces terse ge-1/0/0 and see the output shown in the exhibit. Why are two addresses being shown for this interface? user@r1> show interfaces terse ge-1/0/0 Interface Admin Link Proto Local Remote ge-1/0/0 up up ge-1/0/0.0 up up inet6 fe80::226:88ff:fe02:7481/64 fec0:0:0:2003::1/64
Options
- ATwo addresses are assigned in IPv6, one for the physical and one for the logical interface.
- BTwo addresses are seen because the loopback address of the router is associated with the interface.
- CThe two addresses being seen are the link-local and site-local.
- DAn IPv6 address conflict is being seen; verify your interface configuration for problems.
How the community answered
(20 responses)- A5% (1)
- B5% (1)
- C80% (16)
- D10% (2)
Community Discussion
No community discussion yet for this question.