Juniper
JN0-349 · Question #29
You need to a new ESXi host connected to port ge-0/0/1. One of the VMs configured with VLAN 10 is not reachable from any other device on the switch. To troubleshoot, you decide to verify of the VMs…
The correct answer is A. Show Ethernet-switching table vlan-id 10. See the full explanation below for the reasoning.
Question
You need to a new ESXi host connected to port ge-0/0/1. One of the VMs configured with VLAN 10 is not reachable from any other device on the switch. To troubleshoot, you decide to verify of the VMs MAC address is learned properly under VLAN 10. Which command would you use in this scenario?
Options
- AShow Ethernet-switching table vlan-id 10
- BShow interfaces ge-0/01 detail
- CShow vlans 10
- DMonitor interface ge-0/01
How the community answered
(44 responses)- A82% (36)
- B2% (1)
- C11% (5)
- D5% (2)
Community Discussion
No community discussion yet for this question.