Juniper
JN0-343 · Question #502
You must modify the default RSTP port behavior on interface ge-0/0/9 so it can transition states immediately when a host is plugged in. It is on a half-duplex link. Which command meets this…
The correct answer is C. set protocols rstp interface ge-0/0/9.0 mode point-to-point. See the full explanation below for the reasoning.
Question
You must modify the default RSTP port behavior on interface ge-0/0/9 so it can transition states immediately when a host is plugged in. It is on a half-duplex link. Which command meets this requirement?
Options
- Aset protocols rstp interface ge-0/0/9.0 mode edge
- Bset protocols rstp interface ge-0/0/9.0 mode portfast
- Cset protocols rstp interface ge-0/0/9.0 mode point-to-point
- Dset protocols rstp interface ge-0/0/9.0 mode shared
How the community answered
(48 responses)- A10% (5)
- B8% (4)
- C79% (38)
- D2% (1)
Community Discussion
No community discussion yet for this question.