Juniper
JN0-343 · Question #457
You are viewing the output of the show ospf neighbor command from your routers on a LAN segment and you notice that an interface has the state of 2way. What would be the cause?
The correct answer is B. The interface is between two DROther routers on a broadcast network. See the full explanation below for the reasoning.
Question
You are viewing the output of the show ospf neighbor command from your routers on a LAN segment and you notice that an interface has the state of 2way. What would be the cause?
Options
- AThe two routers cannot communicate with each other.
- BThe interface is between two DROther routers on a broadcast network.
- COne of the routers is waiting for an OSPF start event.
- DOSPF has not been configured on one of the routers.
How the community answered
(31 responses)- A3% (1)
- B84% (26)
- C10% (3)
- D3% (1)
Community Discussion
No community discussion yet for this question.