Juniper
JN0-343 · Question #380
Routers R1, R2, R3, and R4 are all connected on the same OSPF network segment. While viewing the output of the show ospf neighbor command on R1, you notice that the interface towards R2 is always in…
The correct answer is B. R1 and R2 are both DROther devices. See the full explanation below for the reasoning.
Question
Routers R1, R2, R3, and R4 are all connected on the same OSPF network segment. While viewing the output of the show ospf neighbor command on R1, you notice that the interface towards R2 is always in the 2Way state. What would cause this state?
Options
- AR1 is a DR device and R2 is a DROther device.
- BR1 and R2 are both DROther devices.
- CR1 and R2 are both BDR devices.
- DR1 is a DROther device and R2 is a DR device.
How the community answered
(25 responses)- A12% (3)
- B76% (19)
- C4% (1)
- D8% (2)
Community Discussion
No community discussion yet for this question.