Juniper
JN0-334 · Question #8
After a software upgrade on an SRX5800 chassis cluster, you notice that both node0 and node1 are in the primary state, when node1 should be secondary. All control and fabric links are operating…
The correct answer is A. Execute the request system reboot command on node1. See the full explanation below for the reasoning.
Question
After a software upgrade on an SRX5800 chassis cluster, you notice that both node0 and node1 are in the primary state, when node1 should be secondary. All control and fabric links are operating normally. In this scenario, which step must you perform to recover the cluster?
Options
- AExecute the request system reboot command on node1.
- BExecute the request system software rollback command on node0.
- CExecute the request system software add command on node1.
- DExecute the request system reboot command on node0.
How the community answered
(58 responses)- A79% (46)
- B3% (2)
- C5% (3)
- D12% (7)
Community Discussion
No community discussion yet for this question.