Juniper
JN0-333 · Question #2
You are asked to change when your SRX high availability failover occurs. One network interface is considered more important than others in the high availability configuration. You want to prioritize…
The correct answer is D. Configure interface monitor inside the redundancy group that contains the important physical interface; adjust the weight associated with the monitored interface to 255. See the full explanation below for the reasoning.
Question
You are asked to change when your SRX high availability failover occurs. One network interface is considered more important than others in the high availability configuration. You want to prioritize failover based on the state of that interface. Which configuration would accomplish this task?
Options
- ACreate a VRRP group configuration that lists the reth's IP address as the VIP while using each physical interface that make up the reth definition of each SRX HA pair.
- BConfigure IP monitoring of the important interface's IP address and adjust the heartbeat interval and heartbeat threshold to the shortest settings.
- CCreate a separate redundancy group to isolate the important interface; set the priority of the new redundancy group to 255.
- DConfigure interface monitor inside the redundancy group that contains the important physical interface; adjust the weight associated with the monitored interface to 255.
How the community answered
(20 responses)- A5% (1)
- B10% (2)
- C5% (1)
- D80% (16)
Community Discussion
No community discussion yet for this question.