Juniper
JN0-332 · Question #453
When configuring a destination NAT rule, you notice that you are unable to configure the to match condition on an SRX Series device in this scenario, which two statements are correct? (Choose two)
The correct answer is A. Destination NAT occurs before the zone lookup in the flow module D. Destination NAT occurs before the route lookup in the flow module. See the full explanation below for the reasoning.
Question
When configuring a destination NAT rule, you notice that you are unable to configure the to match condition on an SRX Series device in this scenario, which two statements are correct? (Choose two)
Options
- ADestination NAT occurs before the zone lookup in the flow module
- BDestination NAT occurs after the zone lookup in the flow module
- CDestination NAT occurs after the route lookup in the How module
- DDestination NAT occurs before the route lookup in the flow module
How the community answered
(47 responses)- A81% (38)
- B6% (3)
- C13% (6)
Community Discussion
No community discussion yet for this question.