Juniper
JN0-332 · Question #398
Referring to the exhibit, failover to Node 0 occurred for Redundancy Group 2 because of an interface failure. The interface has since been restored, but Node 0 is still the primary node for…
The correct answer is C. Configure preempt under Redundancy Group 2. D. Manually fail over to Redundancy Group 2. See the full explanation below for the reasoning.
Question
Referring to the exhibit, failover to Node 0 occurred for Redundancy Group 2 because of an interface failure. The interface has since been restored, but Node 0 is still the primary node for Redundancy Group 2. Which two actions will restore Node 1 as the primary node for Redundancy Group 2? (Choose two.)
Exhibit
Options
- ADecrease the priority of Node 1 to 100.
- BIncrease the priority of Node 1 to 255.
- CConfigure preempt under Redundancy Group 2.
- DManually fail over to Redundancy Group 2.
How the community answered
(27 responses)- A11% (3)
- B4% (1)
- C85% (23)
Community Discussion
No community discussion yet for this question.