Juniper
JN0-280 · Question #13
Which of the following are correct about OSPF router ID selection? (Choose two)
The correct answer is A. It can be manually configured. B. It is chosen based on the highest IP address of any active interface by default. See the full explanation below for the reasoning.
Question
Which of the following are correct about OSPF router ID selection? (Choose two)
Options
- AIt can be manually configured.
- BIt is chosen based on the highest IP address of any active interface by default.
- CIt is always the IP address of the loopback interface.
- DIt is selected based on the lowest MAC address.
How the community answered
(26 responses)- A81% (21)
- C15% (4)
- D4% (1)
Community Discussion
No community discussion yet for this question.