Juniper
JN0-250 · Question #29
You have just brought online a new site of AP43s. While verifying that everything looks good, you notice that all of the access points (APs) are reporting "insufficient power." The APs are connected…
The correct answer is D. LLDP-MED is not configured on the switch. See the full explanation below for the reasoning.
Question
You have just brought online a new site of AP43s. While verifying that everything looks good, you notice that all of the access points (APs) are reporting "insufficient power." The APs are connected to an 802. 3at-capable switch. In this scenario, what would be the cause of the error?
Options
- AThe cable run to each AP is too long.
- BThe Ethernet cable is plugged into the wrong port on the AP.
- CThe APs' firmware must be upgraded.
- DLLDP-MED is not configured on the switch.
How the community answered
(42 responses)- A2% (1)
- B10% (4)
- C12% (5)
- D76% (32)
Community Discussion
No community discussion yet for this question.