Juniper
JN0-1332 · Question #84
You are asked to design a high availability solution for a customer that wants to use a chassis cluster with two redundancy groups (RG0 and RG1). Their requirements dictate that the Routing Engine…
The correct answer is A. Monitor all interfaces in RG1 only. See the full explanation below for the reasoning.
Question
You are asked to design a high availability solution for a customer that wants to use a chassis cluster with two redundancy groups (RG0 and RG1). Their requirements dictate that the Routing Engine does not failover if RG1 fails. RG1 must failover automatically if there is an interface failure. How would you accomplish this task?
Options
- AMonitor all interfaces in RG1 only.
- BMonitor all interfaces in RG0 only.
- CDo not monitor any interfaces in either redundancy group.
- DMonitor all interfaces in all redundancy groups.
How the community answered
(31 responses)- A81% (25)
- B3% (1)
- C10% (3)
- D6% (2)
Community Discussion
No community discussion yet for this question.