You must apply the family inet configuration parameter only to Gigabit Ethernet interfaces that are in FPC 2. Which output applies to this configuration?

Without the actual configuration snippets, it's impossible to definitively state why these are wrong, but they would be incorrect if they failed to specifically target FPC 2 interfaces, or if they did not use the `family inet` parameter, or if they used an incorrect syntax for groups.

Without the actual configuration snippets, it's impossible to definitively state why these are wrong, but they would be incorrect if they failed to specifically target FPC 2 interfaces, or if they did not use the `family inet` parameter, or if they used an incorrect syntax for groups.

Without the actual configuration snippets, it's impossible to definitively state why these are wrong, but they would be incorrect if they failed to specifically target FPC 2 interfaces, or if they did not use the `family inet` parameter, or if they used an incorrect syntax for groups.

Without the actual output, assuming choice D correctly implements a configuration group that uses wildcards (e.g., `interface ge-2/*/*`) in the `apply-groups` or `apply-macro` section to target only Gigabit Ethernet interfaces on FPC 2 for the `family inet` configuration. This is the Junos best practice for applying configurations to specific sets of interfaces.