JN0-100 · Question #343
After issuing the show interfaces terse command, you notice that the status of one interface is "up down". What does this indicate?
The correct answer is C. The interface is administratively up but the link status is down. Exam Questions, Study Guides, Practice Tests. Lead the way to help you pass any IT Certification exams, 100% Pass Guaranteed or Full Refund. Especially Cisco, CompTIA, Citrix, EMC, HP, Oracle, VMware, Juniper, Check Point, LPI, Nortel, EXIN and so on. Our Slogan: First Test…
Question
After issuing the show interfaces terse command, you notice that the status of one interface is "up down". What does this indicate?
Options
- ALayer 1 on the interface is up but Layer 2 is down.
- BLayer 2 on the interface is up but Layer 3 has not been configured.
- CThe interface is administratively up but the link status is down.
- DThe interface is up but has been administratively turned off.
How the community answered
(39 responses)- A15% (6)
- B8% (3)
- C72% (28)
- D5% (2)
Explanation
Exam Questions, Study Guides, Practice Tests. Lead the way to help you pass any IT Certification exams, 100% Pass Guaranteed or Full Refund. Especially Cisco, CompTIA, Citrix, EMC, HP, Oracle, VMware, Juniper, Check Point, LPI, Nortel, EXIN and so on. Our Slogan: First Test, First Pass. Help you to pass any IT Certification exams at the first try. You can reach us at any of the email addresses listed below. Any problems about IT certification or our products, you could rely upon us, we will give you satisfactory answers in 24 hours.
Community Discussion
No community discussion yet for this question.