HP
HPE6-A75 · Question #36
OSPF is configured on an AOS-Switch, and the network administrator sets the router ID to 10.0.0.1. The administrator wants to be able to reach the switch at this ID from any location throughout the…
The correct answer is B. Configure 10.0.0.1 on a loopback interface, and enable OSPF on that interface. See the full explanation below for the reasoning.
Question
OSPF is configured on an AOS-Switch, and the network administrator sets the router ID to 10.0.0.1. The administrator wants to be able to reach the switch at this ID from any location throughout the OSPF system. The administrator also needs the router ID to De stable and available, even if some links on the switch fail. What should the administrator do?
Options
- AMake sure that 10.0.0.1 is the IP address on the VLAN with the lowest ID.
- BConfigure 10.0.0.1 on a loopback interface, and enable OSPF on that interface.
- CConfigure 10.0.0.1 as a manual OSPF neighbor on each switch in the OSPF system.
- DConfigure 10.0.0.1 as a secondary IP address on the switch 00BM poet.
How the community answered
(34 responses)- A3% (1)
- B79% (27)
- C12% (4)
- D6% (2)
Community Discussion
No community discussion yet for this question.