HP
HPE6-A73 · Question #8
An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and secondary. The VSX LAG fails to establish successfully with a remote switch, however, after…
The correct answer is C. The VSX LAG interfaces are in layer-3 mode. See the full explanation below for the reasoning.
Question
An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and secondary. The VSX LAG fails to establish successfully with a remote switch, however, after verification, the remote switch is configured correctly. The administrator narrows down the problem to the configuration on the AOS-CX switches.
What would cause this problem?
Options
- ALocal optimization was not enabled on the VSX LAG
- BThe VSX LAG hash does not match the remote peer
- CThe VSX LAG interfaces are in layer-3 mode
- DThe LACP was enabled in active mode on the VSX LAG
How the community answered
(27 responses)- A4% (1)
- B4% (1)
- C85% (23)
- D7% (2)
Community Discussion
No community discussion yet for this question.