HPE6-A72 Exam Questions

Given the configuration on the CORE switch shown above, what command would follow to assign the switched virtual interface (SVI) vlan 50 to the VRF created? Core(config)# vrf Green...

Refer to the exhibit. Using the static IP address configured above, what is the converted binary value of the third octet assigned to the local interface?

What is the correct description of a Multi-Layer Switch?

What is true about VSX? (Choose two.)

Refer to the exhibit. What change on Core-1 will result in a successful ping to 10.1.1.254 from the management interface?

The login password to access an Aruba AOS-CX was lost. After connecting to the switch console port, a reboot is performed and the Service OS console is accessed as shown above. Wha...

Refer to the exhibit. The Aruba 8400 in the exhibit is member 2 of a VSX stack. Which command will enter the interface sub configuration mode for the port, indicated by the orange...

What are two features of the three-tier design? (Choose two.)

Refer to the exhibit. The above scenario shows a packet from the Server destined for the Firewall. Switch-A and Switch-B are bundled as VSF stack. The LAG between the VSF stack and...

The shown in blue can be ignored. After completing the above commands, what is the expected output of `show vlan` with no other vlan commanded having been added?

What two OSPF/OSPFv3 attributes within the hello messages that must match to successfully establish neighbor relationships? (Choose two.)

Your customer has 349 users in a two-story building. What are two benefits of a 2-Tier design? (Choose two.)

Which two options are the Layer 3 Routing protocols? (Choose two.)

What are the commands to disable SSH and HTTPS services from the default VRF?

Traffic is falling between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN. Which configuration will correct the issue...

What is an available command on an Aruba AOS-CX switch that would back up the secondary image to a secure remote repository?

The above output is the result of issuing the command show system resource-utilization. The command should be used to enable terminal output line by line or page by page?

Refer to the exhibit. You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master. What is a valid configuration for Acc...

Refer to the exhibit. What are two true regarding VLAN 50 according to the diagram above?

Which command can be used to find the serial number of an Aruba OS-CX switch?

Which statement is true regarding modern switching requirements?

Which statements accurately describe the features of NetEdit? (Choose two.)

What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)

Refer to the exhibit. All four switches in the diagram have been configured with the region name "Aruba1". What two other MSTP configurations must match for switches within the sam...

Which types of routes can be found in the IP routing table of an Aruba AOS-CX switch? (Choose two.)

Which port or ports should be allowed through a firewall so that an AOS-CX switch can act as an SNMP Agent?

You have completed a successful VSF stack between two switches. Without manually assigning a backup switch, what is the expected output when issuing a show vsf command?

What are two methods for remotely managing an Aruba AOS-CX switch? (Choose two.)

Refer to the exhibit. The above command was applied to an Aruba AOS-CX 6300M 24-port switch with 4-port SFP56 uplinks. All ports are set as access switchports. Which ports carry VL...

You are tasked with configuring the Core switch to be managed by NetEdit. Currently, the Core switch is at factory-default settings. Which two steps are missing? (Choose two.)

Which two commands will save the running-config so that changes will be loaded automatically on the next reboot? (Choose two.)

Which two options are correct regarding the IEEE 802.11ax standard? (Choose two.)

What are two OSPF attributes within the hello messages that must match to successfully establish neighbor relationships? (Choose two.)

Drag and Drop Question Match the switching term to the correct definition.

Match each term to its correct definition.

Match each description to the correct term related to switch architecture.

Match each description to the correct management tool for Aruba AOS-CX.

Match the routing protocol term to its correct description.

Click on the colored box that corresponds with the line that best represents Unicast traffic flow.

Match the terms to the correct layer of the OSI model.

Match the available stacking feature to the correct AOS-CX switch model. Stacking features may be used more than once.

Which is the primary benefit SNMPv3 offers that SNMPv2 does not offer?

An Aruba AP-505 uses a tunnel in a campus to the Mobility Controller using which protocol?

Which switch supports a maximum of 8 line-cards, 3 fabric modules, and 2 management cards?

What is the login and password combination is used when first configuring an Aruba OS-CX switch from factory defaults?

What is the little layer Discovery Protocol?

Refer to the exhibit. What commands will display the SVI for vlan 100 on interface 1/1/1 to produce the results displayed in the command show ip interface brief in the exhibit?

What are two features in a 2-Tier design at the Access layer? (Choose two.)

Which network category applies to a SOHO internal network?

The following command is issued: `switch# checkpoint rollback start`. What is the result?