HP
HPE6-A48 · Question #60
During master controller redundancy and failover, these steps occur: 1. Master 1 acts as the primary master and it goes down, therefore, Master 2 takes over as primary. 2. Master 1 comes back up…
The correct answer is B. Preemption enabled, Set VRRP priority of Master 1 and master 2 as default. See the full explanation below for the reasoning.
Question
During master controller redundancy and failover, these steps occur: 1. Master 1 acts as the primary master and it goes down, therefore, Master 2 takes over as primary. 2. Master 1 comes back up again (reboots). 3. Master 2 continues to be the active master. Based on this scenario, how is master redundancy configured on the controller?
Options
- APreemption disabled, Set VRRP priority of Master 1 and master 2 as default.
- BPreemption enabled, Set VRRP priority of Master 1 and master 2 as default.
- CPreemption disabled, Set VRRP priority of Master 1 as 110 and the priority of master 2 as 100.
- DPreemption enabled, Set VRRP priority of Master 1 as 110 and the priority of master 2 as 100.
How the community answered
(22 responses)- A14% (3)
- B73% (16)
- C9% (2)
- D5% (1)
Community Discussion
No community discussion yet for this question.