HP
HPE6-A40 · Question #11
Refer to the exhibit. The network shown in the exhibits is configured with an active and standby controller that uses Layer 3 redundancy for AP termination. There are 100 APs provisioned into the AP…
The correct answer is A. The VLAN mapping is not configured on the standby local controller. Explanation/Reference:
Troubleshoot an Aruba WLAN Solution
Question
Refer to the exhibit. The network shown in the exhibits is configured with an active and standby controller that uses Layer 3 redundancy for AP termination. There are 100 APs provisioned into the AP Group NY1. The active local controller fails and the APs terminate on the standby local controller. Centralized licensing is enabled on the controller cluster with capacity for 100 APs. The WLAN clients are not able to SSID. What could be the source of the problem?
Exhibit
Options
- AThe VLAN mapping is not configured on the standby local controller.
- BThere are not enough licenses on the standby local controller to support the APs
- CThe IP helper address on the interface VLAN is not configured on the standby local controller.
- DThe uplink trunk of the standby controller does not permit the user VLANs for the SSID Layer 3 deployment.
How the community answered
(58 responses)- A76% (44)
- B14% (8)
- C3% (2)
- D7% (4)
Explanation
Explanation/Reference:
Topics
#Layer 3 redundancy#standby controller#VLAN mapping#AP failover
Community Discussion
No community discussion yet for this question.